Explaining about Replacement Window Installation

0 Comments

Rough sills are rarely straight, so you’ll need to change your shims to get a level window resting surface. Get the bottom frame member of the window level while someone keeps the window in place for you. Drill holes in the side frame parts about eight inches down from the top of the window and fasten it in place with screws that aren’t too tight. You may also hammer nails into either side of the glass. When you’re working on it, you’re just trying to keep it from dropping out, check this link right here now.

You’ll need to put shims under the bottom frame member at strategic locations. These shims are important for the window’s longevity. The window will sag if they are not present. A shim should be placed under each vertical window member. Any fixed pane device will also need a shim set under the quarter points. Take a measurement of the fixed pane’s width, for example, 24″. We get 6″ if we divide by four. From each end, measure the distance in. Shims are needed. You’re probably curious as to why. At those points, the manufacturer supports the glass in the frame. The weight of the glass will warp the frame downward at those points if there is no shim under it. It’s something I’ve seen a lot of times. Check to see if all of the shims are more than 16″ apart after these points have been addressed. To get the spacing down to 16″ or less, add more shims as required. Check to see if the bottom is level.

You can almost put your level away on a slider at this stage. It’s just a matter of making the window fit properly if the bottom is level. Simply open the window a little to create a slight gap between the sash and the frame. Adjust the frame with shims until the room is even from top to bottom. Start at the bottom and work your way up. Set the first shim.